Skip to content

Configuring Aximmetry for EZlineup

EZlineup has an integrated connexion to Aximmetry's HTTP API to set the offsets with the click of a button.

1. Configure the HTTP route in EZlineup

Go to Tools/Settings/Network Output:

Select "Aximmetry (HTTP)" as Protocol.

  • The IP is that of the computer running aximmetry.

  • The port should be 21463 unless you changed the default value in Aximmetry.

  • The Target Module is the path to the camera origin node in Aximmetry.

  • The Target Pin tells which in which pin of the module to set the transform.

You will have to adapt these to your Aximmetry project, the default values will not work in general.

The Target Module and Target Pin correspond to the ORIGIN X node in Aximmetry:

2. Send the values to Aximmetry

Once EZlineup is configured, you can send the calibrated values directly to Aximmetry by pressing the send buttons:

In Aximmetry you should see this result: